Stuff I Made 2018-05-14T06:51:07+00:00

Amazing Carbon Fiber Robrenz Camera Arm Build

By | November 18th, 2020|Categories: Featured, Madeit|

I saw a very cool carbon fiber camera arm Robin Renzetti made and have been wanting to make one for quite some time. Link to the original video below. I stayed pretty true to the original design. I used aluminum side clamping plates where Robin used carbon fiber [...]

Introducing the pyEC, a pyBoard Compatible E-Bike Computer

By | February 9th, 2020|Categories: Featured, Madeit, pyEC|

The pyEC is a pyBoard compatible multipurpose board capable of talking with just about anything on your E-bike. In fact it's more a general purpose board capable of doing a whole host of digital electronic tasks. If you are not familiar with the pyBoard, it's a STM32 based board [...]

The Worlds Smallest AVR Programmer! – USBAsp & Arduino Compatible

By | November 21st, 2015|Categories: Madeit|

USBAsp: The tiny AVR programmer Once I got really into Arduinos and starting making my own boards, I found that the cheap programmers I was buying were unreliable. The programmer itself, cable or 10 pin to 6 pin adapter would fail. Another issue I found was that I [...]

Pizza Oven to Reflow Oven Conversion (Controleo2 Clone)

By | August 29th, 2015|Categories: Madeit, Workshop|

4000W SMD Reflow Oven Max PCB size: 620 x 450mm Based on the popular Controleo2 controller (Arduino Compatible Firmware) Overview It's been a couple of years since I made this reflow oven but it's still going strong! The guys over at Whizoo make great oven controllers. Unfortunately I wasn't [...]