Lathe

This is a Chinese made lathe and it a bit on the old side. I did however get the ways ground and replaced all the spindle bearings. It runs pretty well, if a bit loud. I have a large 3 jaw chuck, large 4 jaw chuck, small 3 jaw chuck, small 4 jaw chuck and an ER50 collet holder and full set of collets. I installed a DRO and a quick change tool post. It also has a gap bed, though I haven’t used that yet.

By | 2018-05-09T07:29:05+00:00 May 9th, 2018|Workshop|0 Comments

About the Author:

Brian is an intrepid maker living near Shenzhen China.

Leave A Comment